C&O Leader Romania  
» Septic
» Purification
» Accessories  
» Hydrocarbons
» Fat
» Water
» Street
» Decorative elements
in steel
Do you have questions about our products?
Contact info
(004) 0733/534.754
(004) 0330/560.530
Fat separators
Fat separators
Maintenance & Operation

Fat separators
In general, the mere maintenance of the separator is made after an evacuation program and consists of residual fat and control by observation. Fat accumulated waste will be disposed in a container lid or valve opening of one of the walls of the separator. This program will be well established to prevent overflow of grease waste into drains. It is necessary from time to time the systems used to separate grease from wastewater to carry out major maintenance. These works should be done at least once a year and report maintenance procedure performed must be maintained.

Measurement of sediment accumulation at the base is as follows: a sharp and inflexible rod will be inserted in the separator and will mark higher level, then by pushing down the rod to reach the bottom of the separator, and again you  will measure the distance between the two marks.
Some units have mobile pumps for the base of service maintenance. With this pumps system can be easily evacuated. If no such pumps exists, it will be discharged through the upper cover the amount of fluid inside, and when the liquid level will be minimal and only then will evacuate sediments. After the escape of liquid from the system using a hose with warm water and pressure will try to remove sediment from the base and the walls of the separator, and if not enough will switch to manual cleaning without affecting their internal equipment.
Fat separators
You may also use detergents that do not damage components for interior and exterior cleaning separator. After cleaning will remove water resulting from washing, the control system will perform and if there is no problem the mechanism will be filled with water.

Fat separators Fat separators
Fat separators  
    » Description   » Operating principles
    » Advantages   » Maintenance and operation
    » Dimensioning   » Areas of use
    » Fat generalities   » Fat separators need
    » The importance of collecting fat   » Useful tips
Transportation terms Montage / Installation Special orders
Free consulting Drainage Returning the products
C&O Leader showrooms on map
Bucharest, Iasi, Suceava, Cluj-Napoca, Focsani, Ramnicu Valcea
Rapoarte vizitatori Google Analytics
©2018 C&O LEADER SRL Romania - septic tanks manufacturer, water purification stations, fat & hydrocarbons separators.
Web design & SEO - SANNET®.